When using fiber laser cutting machine, we will do everything possible to reduce its loss on the premise of ensuring its cutting quality. What can we do to reduce its loss?

Before starting the fiber laser cutting machine, push the beam forward and backward by hand, and the trolley can be powered on only after it moves left and right without abnormal noise. When finishing the work of the day, the waste and debris in the machine should be carefully cleaned, so that the machine movement system can avoid being damaged by the operation of foreign objects. Clean its moving parts to keep the machine in good working condition. The specific methods are as follows:

1. Add a little lubricating oil to the screws, including the screws on the laser tube support and the reflector, to facilitate the disassembly and assembly during maintenance. Note: Do not add lubricating oil to the timing belt, drag chain, air pipe, motor, sensor, lens and wire.

2. Do not place objects in the machine to avoid unnecessary damage to the machine.

3. Clean the dust and foreign matters on the metal oil tanker, metal shaft, sliding block and linear guide rail with cotton cloth, then add lubricating oil, and carry out idle reciprocating movement. Optical fiber laser cutting machine is mainly used for metal cutting. The laser beam diameter of the laser cutting machine can reach 0.1 mm, and the cutting diameter on metal materials can reach about 0.2 mm. Therefore, the cutting pattern is very accurate. It not only improves the artistic taste and technical content of sheet metal processing, but also increases the profit margin. So when you operate the fiber laser cutting machine, you must cherish and standardize the operation, so that the equipment can better serve you.